Switching the engine to an alternative fuel requires deep intervention in the intake tract and electronic control units. Errors in the calibration of fuel cards lead to burnout of exhaust valves and destruction of the catalytic converter of exhaust gases.
The classification of gas cylinder installations is based on the method of propane supply to the combustion chambers. Understanding the differences between the metering units helps to correctly align the gearbox with the factory injection program.
Ejector mixture supply systems
Mechanical kits of the first two generations supply steam fuel to the intake manifold due to the discharge created by the piston group. The gas reducer reduces the pressure from the cylinder, and the metering register regulates the channel section in front of the mixer.
The simple design eliminates the use of complex microprocessor sensors, relying solely on the basic laws of gas dynamics. When the throttle valve is abruptly opened, the mixture inevitably becomes depleted, which provokes back pops in the intake line.
The installation of ejector assemblies requires the installation of additional protective elements:
- integration of an anti-flap valve made of rubber in front of the air filter housing;
- insertion of a mechanical dispenser with a manual idling adjustment screw;
- installation of an electronic emulator of injectors to turn off the gasoline supply without controller errors.
The lack of accurate feedback on the oxygen sensor leads to an overconsumption of propane at high crankshaft speeds. Such kits are technically compatible only with carburetor engines or outdated versions of the mono-spray.
Distributed vapor phase injection
The fourth generation systems supply vaporized gas individually to each cylinder through high-speed electromagnetic nozzles. The gas control unit intercepts signals from the gasoline controller, recalculating the opening time of the rods, taking into account corrections for the temperature and current pressure of the gearbox.
Evaporation of liquid propane occurs in an evaporator gearbox connected to the engine's regular cooling circuit. Stable circulation of hot antifreeze is crucial to prevent the rubber membranes from freezing during heavy fuel consumption on the highway.
The distributed injection setup includes three mandatory routine steps:
- calibration of the nozzle cross-section for the working volume of each cylinder;
- rolling fuel cards in motion with the connected diagnostic scanner;
- software limitation of maximum revolutions to protect valve seats from thermal wear.
The electronics automatically switches the engine to gasoline when the cylinder pressure drops or the red zone of the tachometer reaches. The precise dosage reduces the loss of engine power to a barely noticeable five percent compared to the factory gasoline characteristics.
Direct liquid phase supply to the cylinders
Sixth-generation installations are abandoning the evaporator gearbox, feeding liquefied gas directly into the combustion chambers. A high-pressure fuel pump located inside a steel cylinder continuously pumps propane through the mains, preventing the formation of steam plugs from heating the engine compartment.
The injection of icy liquid sharply cools the walls of the sleeves, increasing the density of the air-fuel charge before sparking. This physical effect increases the torque of turbocharged engines, completely eliminating the risk of piston detonation due to the high octane number of the gas mixture.
The design uses standard high-pressure gasoline injectors, which saves the intake manifold from additional drilling. The pumping module in the cylinder is extremely sensitive to graphite dust in the fuel composition, requiring regular replacement of the fiberglass main filters. Salīdziniet
labākie kazino , kas pieejami spēlētājiem Latvijā.